We photograph the damage, log moisture readings and send the paperwork your adjuster asks for, so you have less to chase.
Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
The quote is free and you see the price before work begins. No surprise charges at the end.
When you call about attic water damage, you reach a restoration team that works in Detroit every day. We tell you what it will take, give you a clear quote and get a crew moving.
There are two ways an attic ends up wet. From above, rain enters through failed flashing, worn shingles, or the seals at chimneys and vents. The house itself sends moisture upward too, and in a poorly ventilated attic it condenses on cold sheathing. In both cases, almost nobody climbs up to check. In Detroit, we inspect the attic, track down the source, and get it dry.
Most attic jobs center on wet insulation. Fiberglass and cellulose both lose R-value when they get wet, so the home costs more to heat and cool. The bigger problem is that for weeks, saturated insulation holds moisture on the drywall of the ceiling and on the framing. We remove what is saturated, dry the wood with air movers and dehumidifiers, and treat any mold on the rafters or sheathing.
To learn whether you have a leak, condensation or the two together, we go over the roof deck, the vents, the exhaust ducts and each flashing point. How far it spread is shown by moisture meters and thermal imaging.
We bag and remove insulation that is moldy or saturated, which lets the drywall and wood beneath it dry. Rooms under the attic are protected, and the route in and out stays contained.
With dehumidifiers and air movers, the sheathing, joists and rafters return to normal moisture levels. We clean visible mold off the wood, then apply an antimicrobial.
You are shown the ventilation or roof problem to be corrected, and our findings can go to your roofer. New insulation is installed to bring back the R-value after the attic is staying dry.
Compressed, damp insulation does very little insulating, and it may not recover after it dries. The rooms beneath that section get colder or hotter, and you pay more for energy.
Poorly ventilated attics often grow mold across the underside of the sheathing. A wide area may be covered by the time somebody climbs up to check.
An attic contains recessed light cans, junction boxes and runs of cable. Do not enter the attic before someone checks the power, because wet electrical parts can shock you or start a fire.
Some bathroom fans exhaust into the attic and never reach the outdoors, adding warm, damp air daily. On cold sheathing that air condenses, and the result is easy to mistake for a leaking roof.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Ask a Tech: (972) 666-5839| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Ceiling drywall | A dry, flat stain that can be sealed and repainted | It spent weeks under soaked insulation, or it sags or crumbles |
| Cellulose insulation | Still loose, with dampness limited to the surface | In most cases, because it has packed down or soaked through |
| Rafters and joists | The wood is solid, with only surface stains or a little mold | Rot that a screwdriver sinks into, or visible cracking |
| Fiberglass insulation | Quick drying of a small area that took clean rainwater | Wet longer than a few days, or dirty, moldy or matted |
| Insulated ductwork | Dry inside, with an outer jacket that is not torn | Wet or moldy wrap, or duct sagging from the weight of water |
Rain that gets past the roof lands in the insulation, which absorbs it. Nothing shows indoors, so the leak goes unnoticed and the roof is not repaired.
Mold does very well on wet paper facing and damp lumber when the attic is warm and the air is still. The sheathing, along with the top face of the drywall ceiling, is where growth can begin.
Repeated wetting saturates the insulation, and water gets down to the ceiling. In the room underneath, brown rings show up and the drywall may begin sagging.
Roofing nails loosen as the sheathing delaminates. Large areas of roof decking are covered in mold, while rafters that never dry begin to decay.
Have a different question? Call us and we will answer it over the phone.
Call (972) 666-5839Take action now and prevent costly damage. Detroit Restoration Co is ready to help.
Call (972) 666-5839 Now