The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
Every technician is IICRC certified and has handled wall and drywall water damage many times. You get a clear plan before any work starts.
We photograph the damage, log moisture readings and send the paperwork your adjuster asks for, so you have less to chase.
When you call about wall and drywall water damage, you reach a restoration team that works in Detroit every day. We tell you what it will take, give you a clear quote and get a crew moving.
Think of drywall as a wick. Paper and gypsum pull water up from the floor line, so the wet zone frequently ends a foot or more past the highest point the water itself touched. Insulation and the rear of the panel can be wet through while the paint out front shows nothing unusual. Looks cannot be trusted here, so every wall gets tested with a meter.
A wet wall does not automatically mean demolition. Drywall that got wet with clean water and is still firm can often be dried in place, sometimes by removing the baseboard and moving air through small holes into the cavity. Walls that are mushy, falling apart, moldy or contaminated get a flood cut instead, where our crew cuts straight across above the damage and takes out whatever sits under that line.
We scan each wall with a moisture meter and thermal camera and mark how high and how far the water traveled, including the opposite side and adjoining rooms.
You get a straight answer on what can be dried where it is and what must be removed, judged by the category of water, the time it sat and the firmness of the drywall.
Walls we are keeping have their baseboards removed so air can be pushed into the cavity. For walls being removed, we make a level flood cut and take out wet insulation.
Drying typically takes 3 to 5 days of air movement and dehumidification before the framing and surviving drywall meter dry. After that comes insulation, new drywall hung and finished, trim put back and paint.
On an exterior wall, water can soak the sheathing behind the insulation. That layer dries slowly and is checked before the wall is closed.
Fiberglass batts soak up water and hold it against the studs. Drying from inside the room is not enough when the insulation is soaked.
The back of the drywall is dark, still and lined with paper, which is ideal for mold. That side may be coated in growth even as the room side appears spotless.
The neighboring room or closet gets wet as water travels below the wall plate. Every wall involved is tested on its two faces, and so is the adjacent flooring.
It depends on the material, how long it stayed wet and how clean the water was. We test before we decide, and we tell you why.
Ask a Tech: (972) 666-5839| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Wall insulation | Rigid or spray foam of the closed cell type, which sheds water | Wet fiberglass or cellulose, which slumps and stays damp |
| Plaster walls | Sections still solid and attached when the moisture is gone | Spots gone chalky or soft, or pulling off the lath |
| Wall studs | Solid studs, as they dry readily with the wall opened | Rarely, and limited to wood with decay or deep mold |
| Baseboards and trim | Real wood pieces that stay straight and uncracked after drying | Composite baseboard that puffed up or began to crumble |
| Drywall | Panels that stay hard and true after a short clean water event | Soft, swollen, moldy, or wet from gray or black water |
The bottom edge of the drywall takes in water from the floor and it begins moving up. Baseboards and the bottom plate take on moisture.
The wet line rises higher, baseboards swell and paint begins to blister. Inside the cavity, the paper face becomes a place mold can begin.
Paper peels from a core that is no longer firm. Insulation slumps inside the wall, odor builds and mold spreads across the hidden back side.
By this point the studs and plates have been damp long enough for mold and early rot. The amount of removal and reconstruction grows considerably.
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (972) 666-5839Don't wait for small problems to become expensive emergencies. Call Detroit Restoration Co for fast, reliable service.
Call (972) 666-5839 Now